Translate

Tuesday 10 September 2013

Tiny update

Sorry been a way a while stile doing small prints to calibrate it but at moment stuff is going on and my mind is some where else so im taking a couple of months of continuous working on my printer as i need to take a step back and evaluate my progress so far


this is a shower fix for a friend at work

and a whistle that i had infill problems but i have slowed it down on slicer so hopefully that will solve the problem

1 comment:

  1. Blog is good chris I sorted the stop end problem I had them in the wrong pins
    I only have 2 more problems now yay
    Lcd I will check your other page tomorrow
    And when I press print it goes home then lifts 30mm and prints in the air

    Thx again vin the noob

    ReplyDelete